Get Started

We'll tell you all you need to know to start evaluating and working with this product.

New Wi-Fi Solutions for IoT


Datasheet

PDF

Software

Description

ATWILC1000B

ATWILC1000B Complete

(file size: 2MB, 38 pages, revision B, updated: 03/2016)

ATWILC1000-MR110PB

ATWILC1000-MR110PB Complete

(file size: 1.5MB, 37 pages, revision B, updated: 05/2016)
More Documents...

Atmel® SmartConnect-WILC1000 is an IEEE 802.11 b/g/n IOT link controller SoC. It is the ideal add-On to existing MCU solutions bringing WiFi through UART or SPI/SDIO-to-WiFi interface. The WILC1000 connects to any Atmel AVR or SMART MCU with minimal resource requirements. The WILC1000 most advanced mode is a single stream 1x1 802.11n mode providing up to 72 Mbps PHY throughput. WILC1000 features fully integrated Power Amplifier, LNA, Switch and Power Management. The WILC1000 provides multiple peripheral interfaces including UART, SPI, SDIO and I2C. The only external clock source needed for the WILC1000 is a high-speed crystal or oscillator with a wide variety of reference clock frequencies supported (between 12 – 32 MHz). The WILC1000 is available in a QFN package.

Key Features

  • IEEE 802.11 b/g/n (1x1) for up to 72 Mbps
  • Integrated PA and T/R Switch
  • Superior Sensitivity and Range via advanced PHY signal processing
  • Wi-Fi Direct, station mode and Soft-AP support
  • Supports IEEE 802.11 WEP, WPA2 Security Enterprise
  • On-chip memory management engine to reduce host load
  • SPI, SDIO, UART and I2C as host interfaces

Key Parameters

Parameter
Value

Pin Count:

40

SPI:

1

TWI (I2C):

0

UART:

1

Temp. Range (deg C):

-40 to 85

Operating Voltage (Vcc):

2.5 to 4.2

Frequency Band:

2.4 GHz

Max Data Rate (Mb/s):

72

Antenna Diversity:

No

External PA Control:

No

 

Ordering Information

» Contact your local Atmel Sales Representative.