When doing a firmware upgrade on any tools, the tool needs to be reconnected in another mode than the one used during regular operation. This causes the tool to be re-enumerated, and can cause the tool to be disconnected from the VirtualBox instance and returned to the host operating system.

To make the tool connect automatically to the VirtualBox instance, you need to set up a couple of USB filters. More information on USB filters can be found in the VirtualBox documentation.

Make two filters that are similar to the two shown in Figure 82, “VirtualBox USB filter”.


Note that the example in Figure 82, “VirtualBox USB filter” is specific for the JTAGICE mkII. There are one entry for the tool, here the JTAGICE mkII, and one for AVRBLDR which is the firmware upgrade mode for the tool. The name, serial, Vendor ID and Product ID may be different for your tool, so change those values accordingly.

Note

This section contains specifics to VirtualBox. The same logic applies to other virtualization software, but the steps may differ.